|
|
Post by douche100 on Nov 1, 2005 18:59:07 GMT -5
yesterday I noticed that when running, my rpm gauge didn't go above about 1000, usually @ the speed I was going it runs about 3000 to 3500
boat ran great.
any ideas?
|
|
|
|
Post by FishHawk on Nov 1, 2005 19:32:17 GMT -5
Tach defective? Or possible bad ground.
|
|
|
|
Post by matey on Nov 2, 2005 12:27:17 GMT -5
Bob, sometimes they get a little corrosion around the needle and causes them to stick. i have had the same problem myself. sometimes tapping on the glass will set it free.
|
|
|
|
Post by douche100 on Nov 2, 2005 18:13:28 GMT -5
thanks I'm gonna take a look at it this weekend.
|
|
|
|
Post by take5 on Nov 2, 2005 20:00:25 GMT -5
Tap the gauge if that doesnt work, could also be your voltage regulator. Had to replace my voltage regulator this year. My tach would not work until 3000, then worked fine. Hope it is just a bad gauge
|
|
